Search This Blog

Tuesday, August 30, 2011

Reading a Wiseco piston

Reading a wiseco piston
I recently purchased a set of rings for my Rancher, i does have a wiseco piston in it. At first i had trouble trying to figure out which set of rings to buy, after talking to Helmut he asked me what my bore size was and of course i didnt have an answer. I waited til Monday to call wiseco, and he asked me what the number was on the top of the piston. Now here is a pic of my piston.

   

Now as you can see the Number reads 4933M07850, Now from listening to him i would say the 4933M is the piston series, not sure if it is Honda specific, or just series specific. The last 5 numbers are 07850 which tells you the bore size is 78.50 so when i went to purchase my rings i new what series and bore size i need before i even call them. Dont know if this works for all brand pistons but if you have a wiseco thats how you read the piston.

Gear reductions

gear reduction for all-terrain vehicles (ATV), reduces the drive ratio, thereby increasing the load pulling capacity of the vehicle and providing for a lower-end torque. most gear reductions are made of a carbon steel bar cut to a seventeen-tooth drive gear (as opposed to the original nineteen-tooth drive gear found in typical ATVs). The gear reduction enables the ATV to be more powerful while avoiding major modifications to the motor, thereby eliminating the creation of undesirable heat in the motor.

All-terrain vehicles (ATVs) were created in the 1970's for a variety of purposes, from leisure to agriculture and farming or forestry and construction. Typically they have four wheels and are meant for individual use. Some ATVs are equipped to carry small loads, but do not have a tremendous amount of load-carrying capacity or torque. There is a need for a way of enabling an all-terrain vehicle, to have more low-end power and torque without having to do major modification to the motor of the vehicle, which could lead to overheating.

In times we live in now most gear reductions are installed to allow an ATV to turn larger tires, this is due to the fact that an ATV is not geared to turn most tires larger than 26" in height. We need to realize when doing a gear reduction we increase our low end torque while cutting down on our top end speed. With the ATV industry always changing and seem to have the mind set of GO BIG OR GO HOME, we see tire sizes of up to 32's. You see such tires as the Highlifter Outlaw 2, the INterco Black Mambas.

Daily Pic

Daily Pic
The 300